|
Densifier
MGB 250 HP densifier designed for plastic film reclamation:
The densifier drum is made of a 3/8" thick wear resistant steel plate. The drum is 40" in diameter x 60" high having ten stationary and one rotating blade.
The bottom to the drum is made from a 1" steel plate. The bottom seal for the shaft is a special design to prevent leakage and entry of water to the motor. The support legs are constructed of heavy structural steel tubing and the bottom of the base is made from 3/4" steel plate for additional support. Provisions for bolting down the foundation are also incorporated.
The discharge is approximately 44" from the floor to allow for discharge into a Gaylord box. Direct coupled 250 HP AC TEFC 3 HP exhaust blower.
NEMA 12 control cabinet which will include main curcuit breaker, 250 HP starter (see starter options), breaker and starter for blower, control
transformer,
Starter options for 250 HP densifier:
A. Cross the line full voltage starter.
B. One half part winding starter
C. Electronic soft start, which prolongs motor life and has the potential to save on power use.
D. Air operated tilt table to accommodate Gaylords and /or bales for easier feeding into densifier, complete with cyclinder and controls
|
 |
